HP StorageWorks 2/8-EL - SAN Switch Installation Manual page 47

To install the switch in a rack:
1. Check contents of the shipping carton to verify all the required parts and
2. Choose a mounting location in the rack for the switch.
SAN Switch 2/8 Version 3.1.x Installation Guide
(8) #10 alignment washer
(8) #10 adapter washer
(2) 1/4-20 hex nut with captive star lock washer
(2) 1/4-inch flat washer
Caution: For proper airflow, the SFP media side of the SAN Switch 2/8 must
face the rear of the rack. This mounting allows air to enter from the front of
the rack and to exhaust at the rear of the rack, similar to other rack-mounted
equipment. This prevents switch overheating, which may cause it to fail.
hardware are available.
Installing the SAN Switch 2/8
47