Method 1; Method 2; Swflashdloperstatus; Swflashdladmstatus - HP StorageWorks 2/64 - Core Switch Reference Manual

Method 1

Set swFlashDLHost.0, swFlashDLUser.0, and swFlashDLFile.0 to appropriate host IP address in dot notation
(for example, 192.168.1.7), user name (for example, administrator), and file name of the firmware or
configuration file (for example, /home/fcswh/v4.4), respectively.

Method 2

1. Set swFlashDLPassword.0 to an appropriate value (for example, secret) if FTP is the desired method
of transfer.
2. Set swFlashDLAdmStatus.0 to 3 (swCfUpload) or 4 (swCfDownload), accordingly.

swFlashDLOperStatus

OID
Description

swFlashDLAdmStatus

Supported in Fabric OS 2.6.x and 3.x only.
OID
Description
Note

swFlashDLHost

OID
Description

swFlashDLUser

OID
Description
150 SW MIB objects
1.3.6.1.4.1.1588.2.1.1.1.1.11
The operational status of the flash. Possible values are:
• unknown (0)
• swCurrent (1): The flash contains the current firmware image or configuration file.
• swFwUpgraded (2): The flash contains the image upgraded from the
swFlashDLHost.0.
• swCfUploaded (3): The switch configuration file has been uploaded to the host.
• swCfDownloaded (4): The switch configuration file has been downloaded from the
host.
• swFwCorrupted (5): The firmware in the flash of the switch is corrupted.
1.3.6.1.4.1.1588.2.1.1.1.1.12
The desired state of the flash.
The host is specified in swFlashDLHost.0. In addition, the user name is specified in
swFlashDLUser.0 and the file name specified in swFlashDLFile.0. Possible values are:
• swCurrent (1): The flash contains the current firmware image or configuration file.
• swCfUpload (3): The switch configuration file is to be uploaded to the specified host.
• swCfDownload (4): The switch configuration file is to be downloaded from the
specified host.
• swFwCorrupted (5): The firmware in the flash is corrupted. This value is for
informational purposes only; however, setting swFlashDLAdmStatus to this value is not
allowed.
For more information about the configDownload and configUpload commands, see
the HP StorageWorks Fabric OS 5.x command reference guide.
1.3.6.1.4.1.1588.2.1.1.1.1.13
The name or IP address (in dot notation) of the host to download or upload a relevant file
to the flash.
1.3.6.1.4.1.1588.2.1.1.1.1.14
The user name is used on the host for downloading or uploading a relevant file, to or from
the flash.