HP Rp7410 - Server - 0 MB RAM Administrator's Manual page 265

-f
-c cell
-i IOchassis
-C
-I
-l cabinet
-u username
-g
-h IPaddress|hostname
Power off the specified cells or I/O chassis.
The specified cell is powered on/off or the power status is
displayed.
A cell can be specified either in the local (cabinet/slot) or global
(cell_ID) format.
The specified IOchassis is powered on/off or the power status
is displayed.
Display power status of all cells. By default the scope is the
entire complex if the -l option is not specified.
Display power status of all I/O chassis. The scope is the entire
complex if the -l option is not specified.
Limit the scope of the -C or -I option to the specified cabinet.
Enhanced nPartition Commands only. Specifies the account
and authorization to access an nPartition other than the local
nPartition.
The -h option is required if this option is used.
username specifies a configured user name on the target
nPartition.
Enhanced nPartition Commands only. Allows access to the
complex specified by the -h option. The accessed complex is
then considered the target complex. Access is through the
service processor LAN port.The -h option is required if this
option is used.
Enhanced nPartition Commands only. This option is only used
in combination with either the -u or -g option.
IPaddress|hostname specifies the IP address or hostname of the
target nPartition (-u) or service processor (-g).
frupower Command 265