A Npartition Commands; Specifying Cells And I/O Chassis To Commands; Cell Specification Formats; Cell Ids In Global Cell Number Format - HP Rp7410 - Server - 0 MB RAM Administrator's Manual

A nPartition Commands

This appendix has details and command-line syntax for the HP nPartition Commands, including
both the Original nPartition Commands and the Enhanced nPartition Commands.
• The Original nPartition Commands were distributed as part of HP-UX 11i v1 (B.11.11)
releases prior to the December 2004 release.
• The Enhanced nPartition Commands are distributed with current HP-UX releases, including
HP-UX 11i v3 (B.11.31), all releases of HP-UX 11i v2 (B.11.23), and releases of HP-UX 11i v1
(B.11.11) beginning with the December 2004 release.
The Enhanced nPartition Commands also are distributed as bundles on the HP Smart Setup
CD for Windows, and as bundles on the HP Integrity Essentials Foundation Pack for Linux.
For an introduction to the nPartition Commands, see
(page 19). This appendix provides the following reference information for using HP nPartition
Commands:
• "parcreate Command" (page 249)
• "parmodify Command" (page 252)
• "parremove Command" (page 256)
• "parstatus Command" (page 258)
• "parunlock Command" (page 260)
• "fruled Command" (page 262)
• "frupower Command" (page 264)
• "cplxmodify Command" (page 266)
Commands.
NOTE: For the most current information for these commands, refer to the online manpages:
parcreate(1M), parmodify(1M), parremove(1M), parstatus(1), parunlock(1M), fruled(1M), frupower(1M),
and cplxmodify(1M).
On a Windows system, refer to Start Programs Hewlett-Packard nPar Management nPar
Commands Manual.

Specifying Cells and I/O Chassis to Commands

Use the cell and I/O chassis notation described in this section when you manage, configure, and
inquire about cells and I/O chassis using the nPartition configuration commands.
Details are in the

Cell Specification Formats

Use either of the following two formats to specify cells when using the nPartition configuration
commands: "Global Cell Number Format"
• Global Cell Number Format
hardware path, as reported by the HP-UX ioscan command. In global format, each cell is
given a single unique number that indicates the relative location of the cell in the entire
server complex.
Table A-1 Cell IDs in Global Cell Number Format
Cell Slot
Global Format for
rp7405/rp7410, rp7420,
rp7440, rx7620, and
rx7640
"Cell Specification Formats"
The global cell number format is identical to the cells' HP-UX
0 1
0 1
"Commands for Configuring nPartitions"
— Only supported by the Enhanced nPartition
and "I/O Specification Format"
or "Cell Hardware Location
2 3 4
— — —
Specifying Cells and I/O Chassis to Commands
sections that follow.
Format".
5 6 7
— — —
243