Parremove Command - HP Rp7410 - Server - 0 MB RAM Administrator's Manual

parremove Command

The parremove command removes an existing nPartition. This removes all cells from the
nPartition and destroys the nPartition definition. Root permission or IPMI LAN access is required
to run this command.
• To remove the local nPartition, you must specify the -F option.
For the Original nPartition Commands, the local nPartition is the one from which you issue
the parremove command.
For the Enhanced nPartition Commands, the local nPartition either is the one where the
command is issued, or if the -u... -h... options are specified it is the nPartition whose
host is specified by -h.
• To remove a remote nPartition using the Original nPartition Commands, the remote nPartition
must be inactive: it must be shutdown for reconfig or the parremove command will not be
able to remove the nPartition.
When using the Enhanced nPartition Commands, parremove can remove an active, remote
nPartition when both the -Foption and the -g... -h... set of options are specified.
NOTE: On servers based on the HP sx1000 chipset or HP sx2000 chipset, when the nPartition
Configuration Privilege is restricted the parremove command cannot remove an nPartition
unless the command is issued with the -g... -h... options.
Refer to the parremove(1M) manpage for complete details.
Synopsis
parremove -p PartitionNumber [-F]
Enhanced nPartition Commands Notes
• The -u... -h... set of options may be specified to cause the command to send its
management request using WBEM to an nPartition other than the local nPartition (but can
also be used as a "loopback access" to the local nPartition).
• The -g... -h... options may be specified to cause the command to send its management
request using IPMI over LAN to a service processor in another server complex (but can also
be used as a "loopback access" to the service processor in the local complex).
The -u and -g options are mutually exclusive.
Options
-p PartitionNumber
-F
-u username
-g
256 nPartition Commands
Specifies the nPartition number to be removed.
Forcibly remove the nPartition. If the nPartition is inactive, the
nPartition is removed. If the nPartition is active and if it is the
local nPartition, the nPartition is removed.
If the nPartition is active but is not the local nPartition, then
the nPartition will not be removed.
Enhanced nPartition Commands only. Specifies the account
and authorization to access an nPartition other than the local
nPartition.
The -h option is required if this option is used.
username specifies a configured user name on the target
nPartition.
Enhanced nPartition Commands only. Allows access to the
complex specified by the -h option. The accessed complex is
then considered the target complex. Access is through the
service processor LAN port.The -h option is required if this
option is used.