HP Rp7410 - Server - 0 MB RAM Administrator's Manual page 251

-rcell
-T flag
-B
-u username
-g
-h IPaddress|hostname
Specifies the core cell choices. One to four cells can be
specified.
Specifies whether Hyper-Threading should be enabled or
not (only if cells support this feature). By default
Hyper-Threading is disabled.
The valid values for flag are:
y Enable Hyper-Threading, which allows multiple
threads to run concurrently on each processor core.
n Disable Hyper-Threading. This is the default value.
Specifies to boot the nPartition. The default is not to boot
the nPartition and leave it in the shutdown for reconfig
state.
Enhanced nPartition Commands only. Specifies the account
and authorization to access an nPartition other than the
local nPartition.
The -h option is required if this option is used.
username specifies a configured user name on the target
nPartition.
Enhanced nPartition Commands only. Allows access to
the complex specified by the -h option. The accessed
complex is then considered the target complex. Access is
through the service processor LAN port.The -h option is
required if this option is used.
Enhanced nPartition Commands only. This option is only
used in combination with either the -u or -g option.
IPaddress|hostname specifies the IP address or hostname of
the target nPartition (-u) or service processor (-g).
parcreate Command 251