#
---
0)
1)
Select a partition number: 0
Do you want to TOC partition number 0? (Y/[N]) y
-> The selected partition will be TOCed.
GSP:CM>
3.
After you initiate the TOC, you can observe its progress and select the type of crash dump
through the nPartition console.
Once the nPartition completes the dump, or once you cancel it, the nPartition reboots.
******* Unexpected TOC. Processor HPA FFFFFFFF'FC07C000 *******
r00/03 00000000'00000000 00000000'0099CA2C 00000000'00000000 00000000'010BB790
r04/07 00000000'00000002 00000000'010BC140 00000000'0080F000 00000000'00AA2490
r08/11 00000000'00000001 00000000'0099A800 00000000'0099A800 00000000'0099C800
....
Processor 8 TOC:
Boot device reset done.
*** The dump will be a SELECTIVE dump:
*** To change this dump type, press any key within 10 seconds.
*** Proceeding with selective dump.
*** The dump may be aborted at any time by pressing ESC.
*** Dumping:
Booting and Shutting Down HP-UX
This section has procedures for booting and shutting down HP-UX on cell-based HP servers and
a procedure for adding HP-UX to the boot options list on HP Integrity servers.
•
To check whether the cell local memory (CLM) configuration is appropriate for HP-UX,
refer to
"HP-UX Support for Cell Local Memory" (page
•
To add an HP-UX entry to the nPartition boot options list on an HP Integrity server refer to
"Adding HP-UX to the Boot Options List" (page
•
To boot HP-UX refer to
•
To shut down HP-UX refer to
HP-UX Support for Cell Local Memory
On servers based on the HP sx1000 chipset or HP sx2000 chipset, each cell has a cell local memory
(CLM) parameter, which determines how firmware interleaves memory residing on the cell.
108
Booting and Resetting nPartitions
partition.
Name
----
jules00
jules01
pcsq.pcoq = 0'0.0'12675c
isr.ior
= 0'10340004.0'2f8bfd30
7% complete (32 of 457 MB) (device 64:0x2)
"Booting HP-UX" (page
"Shutting Down HP-UX" (page
GENERAL REGISTERS:
457 of 4080 megabytes.
109).
110).
108).
117).
Need help?
Do you have a question about the Rp7410 - Server - 0 MB RAM and is the answer not in the manual?