Shutting Down Hp Openvms - HP Rp7410 - Server - 0 MB RAM Administrator's Manual

3. Access the EFI System Partition (fsX: where X is the file system number) for the device
from which you want to boot HP OpenVMS.
For example, enter fs2: to access the EFI System Partition for the bootable file system
number 2. The EFI Shell prompt changes to reflect the file system currently accessed.
Also, the file system number might change each time it is mapped (for example, when the
system boots, or when the map -r command is issued).
4. When accessing the EFI System Partition for the desired boot device, issue the
\efi\vms\vms_loader command to initiate the vms_loader.efi loader on the device
you are accessing.
fs5:> \efi\vms\vms_loader.efi
HP OpenVMS Industry Standard 64 Operating System, Version V8.2-1
Copyright 1976-2005 Hewlett-Packard Development Company, L.P.
%PKA0, Copyright (c) 1998 LSI Logic PKW V3.2.20 ROM 4.19
%PKA0, SCSI Chip is SYM53C1010/66, Operating mode is LVD Ultra3 SCSI
%SMP-I-CPUTRN, CPU #01 has joined the active set.
%SMP-I-CPUTRN, CPU #02 has joined the active set.
...
5. Exit the console and management processor interfaces when finished using them.
To exit the EFI environment type ^B (Control-B); this exits the system console and returns
to the management processor Main Menu. To exit the management processor, type X at the
Main Menu.

Shutting Down HP OpenVMS

This section describes how to shut down the HP OpenVMS OS on cell-based HP Integrity servers.
Procedure 5-18 Shutting Down HP OpenVMS
From the HP OpenVMS command line, issue the @SYS$SYSTEM:SHUTDOWN command to shut
down the OpenVMS OS.
1. Log in to HP OpenVMS running on the system that you want to shut down.
You should log in to the MP for the server and use the Console menu to access the system
console. Accessing the console through the MP enables you to maintain console access to
the system after HP OpenVMS has shut down.
Booting and Shutting Down HP OpenVMS I64 123