Removing The Lcd System Information Display Panel - Lenovo x3550 M5 Installation And Service Manual

Step 4. For the four 3.5-inch hot-swap or simple-swap hard disk drive server configuration, slide the
operator information panel into the chassis from the inside of the server; then, reconnect the
operator information panel assembly cable to the system board.
Figure 169. Operator information panel assembly installation for four 3.5-inch hot-swap or simple-swap hard
disk drive server configuration
Step 5. Reconnect the operator information panel assembly cable to the operator information panel
assembly. This step applies to all types of server configurations.
Step 6. Reinstall the cover (see "Replacing the cover" on page 120).
Step 7. Slide the server into the rack.
Step 8. Reconnect the power cords and any cables that you removed.
Step 9. Turn on the peripheral devices and the server.

Removing the LCD system information display panel

Use this information to remove the LCD system information display panel.
To remove the LCD system information display panel, complete the following steps.
Note: The LCD system information display panel is available only in the ten 2.5-inch hot-swap hard disk
drive server configuration.
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
246
Lenovo System x3550 M5 Installation and Service Guide
Operator information
panel connector