Troubleshooting; Basic Troubleshooting Chart - Kyocera KM-2540 Operation Manual

3 Troubleshooting

Basic troubleshooting chart

If you experience trouble while you are using this machine as a printer, refer to the table
below to perform minor adjustments. If trouble persists, contact your service representative
or an authorized service center.
NOTE:
the Operation Guide for your copier.
Problem
Nothing is printed out
Text is not printed correctly Is the printer cable appropriate
Print out is not correct
For information in regard to general mechanical trouble with the machine, refer to
Check point
Is the power cord loose?
Is the power on to the printer? Turn the main switch to the printer on.
Is the printer cable appropriate
and is it connected properly?
Did you connect the printer
cable after you turned the
power to the printer On?
Is the printer off-line? (Is the
Status indicator flashing
amber?)
and is it connected properly?
Is the setting configuration in
your PC correct?
Is the emulation protocol
setting correct?
Procedure
Connect the power cord securely to a power
source.
Be sure to use a compliant printer cable and
make sure it is connected properly.
Connect the printer cable before you turn the
power to the printer on.
Perform the appropriate procedure to put the
printer on-line.
Press the [Print] key to switch to the printer
mode.
Press [GO].
The Status indicator will go out.
Be sure to use a compliant printer cable and
make sure it is connected properly.
Confirm the settings in the printer driver as well
as in the software application in use.
Check the emulation protocol setting.
3-1