Using The Ram Disk - Kyocera KM-2540 Operation Manual

Selecting the Printer Settings
2
Press [List of Partitions].
3 Press [Printing].
The message Processing data appears and the list of partitions prints.
4
After the list of partitions is printed, the display returns to the Printer menu screen.

Using the RAM Disk

This machine is equipped with RAM disk functions. The RAM disk is a virtual disk unit that
uses a part of the memory. If you assign a certain size of the memory to the RAM disk, you
can use it for electronic sorting (for reduction of total print time) and storage and reading of
data. Also you can use the e-MPS function.
To activate RAM disk in the printer's memory, first you must set the RAM disk mode to On
and set the desired data size for the RAM disk as described in the following section. This
allows you to perform the following operations on the RAM disk.
•
•
•
•
IMPORTANT: The RAM disk can not be used when an optional hard disk is installed. The
RAM disk stores data only temporarily. When the machine is reset or turned off, the stored
data will be erased. The RAM disk is allocated within the printer's memory available to
users. If the size of the RAM disk is set too large, the printing speed may decrease or the
memory may become insufficient.
2-34
Writing Data
Printing a List of Data Names (Partitions)
Reading Data (Data and Program Data)
Deleting Data (Data, Program Data, Font Data, and Macro Data)
Memory Card
Read
Write Data
List of
Data
Partitions
Format Font
Printer menu
Delete
Language
Program Data
Macro Font