Snmp Trap Configuration Parameters - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

Operands
trap [trap_number]
Prompts you in a line-by-line fashion to change SNMP trap parameters for the trap number given
by [trap_number]. [trap_number] can be 1–5. For each parameter, enter a new value or press
Enter to accept the current value. To configure common parameters and trap parameters, omit the
trap operand.
Table 52

SNMP trap configuration parameters

Parameter
Trap [1-5] Address
Trap [1-5] Port
Trap [1-5] Severity
Trap [1-5] Version
Trap [1-5] Enabled
Examples The following is an example of the set setup snmp common command:
8/20q FC Switch (admin) #> set setup snmp common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
SnmpEnabled
Contact
Location
ReadCommunity
WriteCommunity
AuthFailureTrap
ProxyEnabled
SNMPv3Enabled
New Value (press ENTER to not specify value, 'q' to quit):
SnmpEnabled
Contact
Location
ReadCommunity
WriteCommunity
AuthFailureTrap
ProxyEnabled
SNMPv3Enabled
Do you want to save and activate this snmp setup? (y/n): [n]
Table 52 describes the trap parameters.
Description
Specifies the workstation IP address to which SNMP traps are sent. The
default address for trap 1 is 10.0.0.254. The default address for traps
2–5 is 0.0.0.0. Addresses, other than 0.0.0.0, for all traps must be
unique.
Specifies the workstation port to which SNMP traps are sent. Valid
workstation port numbers are 1–65535. The default is 162.
Specifies the severity level to use when monitoring trap events. The
default is Warning.
Specifies the SNMP version (1 or 2) to use in formatting traps. The
default is 2.
Specifies whether traps (event information) are enabled (True) or
disabled (False). The default is False.
True
<sysContact undefined>
<sysLocation undefined>
public
private
False
True
False
(True / False)
(string, max=64 chars) :
(string, max=64 chars) :
(string, max=32 chars) :
(string, max=32 chars) :
(True / False)
(True / False)
(True / False)
8/20q Fibre Channel Switch command line interface guide 225
:
:
:
: