Command Line Interface Usage; Logging In To The Switch Through Telnet - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

1

Command line interface usage

This section describes the following tasks:
• Logging in to the switch through
• Opening and closing an admin
• Entering commands, page 16
• Getting help, page 17
• Setting page
• Creating a support
• Downloading and uploading
NOTE: Throughout this document, references in the text to commands and keywords use initial
capitalization for clarity. Actual command and operand entries are not case-sensitive.

Logging in to the switch through Telnet

To log in to a switch through Telnet:
1. Open a command line window on the workstation and enter the telnet command followed by the
switch Internet Protocol (IP) address:
# telnet ip_address
The IP address can be one of the following:
• 4-byte IP version 4 (IPv4) address
• 16-byte IP version 6 (IPv6) address
• Domain Name System (DNS) host name (requires a DNS server)
The Telnet window opens prompting you for a login.
2. Enter an account name and password. The default account name is admin, and its password is
password.
switch login:admin
password: xxxxxxxx
The following warning appears each time you log in until you change the default password.
Warning:
recommended that you do so before proceeding.
To log off, enter the exit command:
8/20q FC Switch #> exit
Telnet, page 15
session, page 16
breaks, page 17
file, page 17
files, page 19
Your user account password has not been changed. It is strongly
8/20q Fibre Channel Switch command line interface guide 15