Displaying The Event Log Configuration; Restoring The Event Log Configuration; Clearing The Event Log; Logging To A Remote Host - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

The following example configures the event log to record switch management events with warning and
critical severity levels associated with ports 0–3. Entering the set log save command ensures that this
configuration is preserved across switch resets.
8/20q FC Switch (admin) #> set log component switch
8/20q FC Switch (admin) #> set log level warn
8/20q FC Switch (admin) #> set log port 0 1 2 3
8/20q FC Switch (admin) #> set log save

Displaying the event log configuration

To display all event log configuration settings, enter the show log settings command, as shown in the
following example:
8/20q FC Switch #> show log settings
Current settings for log
------------------------
Started
FilterComponent
QFS
FilterLevel
DisplayLevel
FilterPort

Restoring the event log configuration

To return the event log configuration to the factory default, enter the set log restore command in an
Admin session, as shown in the following example:
8/20q FC Switch (admin) #> set log restore

Clearing the event log

To delete all entries in the event log, enter the set log clear command in an Admin session, as shown
in the following example:
8/20q FC Switch (admin) #> set log clear

Logging to a remote host

The switch comes from the factory with local logging enabled, which instructs the switch firmware to
maintain an event log in switch memory. The switch can also be configured to log events to a remote host
that supports the syslog protocol. This, however, requires that you enable remote logging on the switch and
specify an IP address for the remote host.
NOTE: To log event messages on a remote host, you must edit the syslog.conf file on the remote host
and then restart the syslog daemon. The syslog.conf file must contain an entry that specifies the name
of the log file. Add the following line to the syslog.conf file. Note that in this command, a <tab>
separates the selector field (local0.info) from the action field, which contains the log file path name
(/var/adm/messages/messages.name).
local0.info <tab> /var/adm/messages/messages.name
Consult your host operating system documentation for information on how to configure remote logging.
108 Event log configuration
True
NameServer MgmtServer Zoning Switch Blade Port Eport Snmp CLI
Info
Critical
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20