Show Switch; Switch Operational Parameters - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

show switch

Description Displays switch operational information.
Authority None
Syntax
show switch
Notes Table 66
Table 66
Parameter
SymbolicName
SwitchWWN
BootVersion
CreditPool
DomainID
FirstPortAddress
FlashSize - MBytes
LogFilterLevel
MaxPorts
NumberOfResets
ReasonForLastReset
ActiveImageVersion-build
date
PendingImageVersion-build
date
ActiveConfiguration
AdminState
AdminModeActive
BeaconOnStatus
OperationalState
PrincipalSwitchRole
POSTFaultCode
POSTStatus
TestFaultCode
TestStatus
BoardTemp (1) - Degrees
Celsius
SwitchTemperatureStatus
278 Command reference
describes the switch operational parameters.

Switch operational parameters

Description
Descriptive name for the switch
Switch worldwide name
Programmable Read-only Memory (PROM) boot version
Number of port buffer credits available to recipient ports
Switch domain ID
Fibre Channel address of switch port 0
Size of the flash memory, in megabytes
Event severity level, used to record events in the event log
Number of ports available on the switch
Number of times the switch has been reset over its service
life
Action that caused the last reset
Active firmware image version and build date
Firmware image version and build date that is pending.
This image will become active at the next reset or
power-cycle.
Name of the switch configuration that is in use.
Switch administrative state
Admin session status
Beacon status as set by the set beacon command
Switch operational state
Principal switch status. True indicates that this switch is the
principal switch.
Fault code from the most recent power-on self test
Status from the most recent power-on self test
Fault code from the most recent switch test
Status from the most recent switch test
Internal switch temperature at circuit board sensor 1
Normal, warning, failure