HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual page 203

Examples The following is an example of the set config port command:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> config edit
8/20q FC Switch (admin-config) #> set config port 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number:
------------------------
AdminState
LinkSpeed
PortType
SymPortName
ALFairness
DeviceScanEnable (True / False)
ForceOfflineRSCN (True / False)
ARB_FF
InteropCredit
FANEnable
AutoPerfTuning
MSEnable
NoClose
IOStreamGuard
PDISCPingEnable
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
See also config, page 142
show config
1
(1=Online, 2=Offline, 3=Diagnostics, 4=Down)
(1=1Gb/s, 2=2Gb/s, 4=4Gb/s, 8=8Gb/s, A=Auto)
(GL, G, F, FL, TR )
(string, max=32 chars)
(True / False)
(True / False)
(decimal value, 0-255)
(True / False)
(True / False)
(True / False)
(True / False)
(Enable / Disable / Auto)
(True / False)
port, page 241
8/20q Fibre Channel Switch command line interface guide 203
[Online]
[Auto ]
[GL ]
[Port1 ]
[False ]
[True ]
[False ]
[False ]
[0 ]
[True ]
[True ]
[True ]
[False ]
[Auto ]
[True ]