Set Port; Transmission Speed Parameters; Port Administrative State Parameters - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

set port

Description Sets port state and speed for the specified port temporarily until the next switch reset or new
configuration activation. This command also clears port counters.
Authority Admin session
Syntax
set port clear
or
set port [port_number]
clear
speed [transmission_speed]
state [state]
Operands
[port_number]
Specifies the port. Ports are numbered beginning with 0.
clear
Clears the counters on all ports or the port given by [port_number].
speed [transmission_speed]
Specifies the port transmission speed.
Table 45

Transmission speed parameters

Parameter
2Gb/s
4Gb/s
8Gb/s
Auto
state [state]
Specifies the port administrative state.
parameters.
Table 46

Port administrative state parameters

Parameter
Online
Offline
Diagnostics
Down
See also show port, page 265
Table 45
Description
The port speed is 2 Gb/s.
The port speed is 4 Gb/s.
The port speed is 8 Gb/s.
The port speed is automatically detected.
Table 46
Description
Activates and prepares the port to send data
Prevents the port from receiving signal and accepting a device login
Prepares the port for testing and prevents the port from accepting a device
login
Disables the port by removing power from the port lasers
8/20q Fibre Channel Switch command line interface guide 215
describes the transmission speed parameters.
describes the port administrative state