Snmp Trap Configuration Parameters - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

Fibre channel switch
Hide thumbs Also See for AK241A - StorageWorks 8Gb Simple SAN Connection:
Table of Contents

Advertisement

Operands
trap [trap_number]
Prompts you in a line-by-line fashion to change SNMP trap parameters for the trap number given
by [trap_number]. [trap_number] can be 1–5. For each parameter, enter a new value or press
Enter to accept the current value. To configure common parameters and trap parameters, omit the
trap operand.
Table 52
Parameter
Trap [1-5] Address
Trap [1-5] Port
Trap [1-5] Severity
Trap [1-5] Version
Trap [1-5] Enabled
Examples The following is an example of the set setup snmp common command:
8/20q FC Switch (admin) #> set setup snmp common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
New Value (press ENTER to not specify value, 'q' to quit):
Do you want to save and activate this snmp setup? (y/n): [n]
220 Command reference
Table 52
describes the trap parameters.

SNMP trap configuration parameters

Description
Specifies the workstation IP address to which SNMP traps are sent. The
default address for trap 1 is 10.0.0.254. The default address for traps
2–5 is 0.0.0.0. Addresses, other than 0.0.0.0, for all traps must be
unique.
Specifies the workstation port to which SNMP traps are sent. Valid
workstation port numbers are 1–65535. The default is 162.
Specifies the severity level to use when monitoring trap events. The
default is Warning.
Specifies the SNMP version (1 or 2) to use in formatting traps. The
default is 2.
Specifies whether traps (event information) are enabled (True) or
disabled (False). The default is False.
SnmpEnabled
True
Contact
<sysContact undefined>
Location
<sysLocation undefined>
ReadCommunity
public
WriteCommunity
private
AuthFailureTrap
False
ProxyEnabled
True
SNMPv3Enabled
False
SnmpEnabled
(True / False)
Contact
(string, max=64 chars) :
Location
(string, max=64 chars) :
ReadCommunity
(string, max=32 chars) :
WriteCommunity
(string, max=32 chars) :
AuthFailureTrap
(True / False)
ProxyEnabled
(True / False)
SNMPv3Enabled
(True / False)
:
:
:
:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks sn6000 - fibre channel switch8/20q

Table of Contents