Custom Firmware Installation; Testing A Switch - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

Custom firmware installation

A custom firmware installation downloads the firmware image file from a remote host to the switch,
unpacks the image file, and resets the switch in separate steps. This allows you to choose the type of switch
reset and whether the activation will be disruptive (reset switch command) or non-disruptive
(Hotreset command). The following example illustrates a custom firmware installation with a
non-disruptive activation.
1. Download the firmware image file from the workstation to the switch.
• If your workstation has an FTP server, you can enter the image fetch command:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> image fetch account_name ip_address
filename
• If your workstation has a TFTP server, you can enter the image tftp command to download the
firmware image file.
8/20q FC Switch (admin) #> image tftp ip_address filename
• If your workstation has neither an FTP nor a TFTP server, open an FTP session and download the
firmware image file by entering the following FTP commands:
>ftp ip_address or switchname
user:images
password: images
ftp>bin
ftp>put filename
ftp>quit
2. Display the list of firmware image files on the switch to confirm that the file was loaded:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) $> image list
3. Unpack the firmware image file to install the new firmware in flash memory.
8/20q FC Switch (admin) $> image unpack filename
4. Wait for the unpack to be completed.
Image unpack command result: Passed
5. A message will prompt you to reset the switch to activate the firmware. Use the hotreset command to
attempt a non-disruptive activation. If the non-disruptive activation fails, you will usually be prompted to
try again later. Otherwise, the switch will perform a disruptive activation.
8/20q FC Switch (admin) $> hotreset

Testing a switch

You can test all ports on a switch using the test switch command. There are three test types: online,
offline, and connectivity. See
The following sections describe the test types, how to display test status, and how to cancel a switch test:
• Online tests for
• Offline tests for
• Connectivity tests for
• Displaying switch test
• Canceling a switch
56 Switch configuration
"Testing a port" on page 71.
switches, page 57
switches, page 57
switches, page 57
status, page 58
test, page 58