Radius Server Configuration; Displaying Radius Server Information - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

9

RADIUS server configuration

Authentication can be performed locally using the switch's security database, or remotely using a Remote
Dial-In User Service (RADIUS) server such as Microsoft RADIUS. With a RADIUS server, the security
database for the entire fabric resides on the server. In this way, the security database can be managed
centrally, rather than on each switch. However, when using a RADIUS server, every switch in the fabric
must have a network connection. You can configure up to five RADIUS servers to provide failover.
You can configure a RADIUS server to authenticate only the switch or both the switch and the initiator
device, if the device supports authentication. A RADIUS server can also be configured to authenticate user
accounts. See
user logins with a RADIUS server. See
This section describes the following tasks:
• Displaying RADIUS server
• Configuring a RADIUS server on the

Displaying RADIUS server information

To display RADIUS server information, enter the show setup radius command, as shown in the
following example. For information about RADIUS server configuration parameters, see
8/20q FC Switch #> show setup radius
Radius Information
------------------
DeviceAuthOrder
UserAuthOrder
TotalServers
Server: 1
ServerIPAddress
ServerUDPPort
DeviceAuthServer
UserAuthServer
AccountingServer
Timeout
Retries
SignPackets
Secret
Server: 2
ServerIPAddress
ServerUDPPort
DeviceAuthServer
UserAuthServer
AccountingServer
Timeout
Retries
SignPackets
Secret
"User account configuration" on page 21. A secure connection is required to authenticate
"Connection security
information, page 101
Local
Local
2
10.0.0.13
1812
False
False
False
2
0
False
********
bacd:1234:bacd:1234:bacd:1234:bacd:1234
1812
True
True
True
2
0
False
********
configuration" on page 87.
switch, page 102
8/20q Fibre Channel Switch command line interface guide 101
Table 48.