The following is an example of the set setup system timers command:
8/20q FC Switch (admin) #> set setup system timers
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
AdminTimeout
InactivityTimeout
New Value (press ENTER to accept current value, 'q' to quit):
AdminTimeout
InactivityTimeout
Do you want to save and activate this system setup? (y/n): [n]
See also
show setup
system, page 275
30
0
(dec value 0-1440 minutes, 0=never) :
(dec value 0-1440 minutes, 0=never) :
8/20q Fibre Channel Switch command line interface guide 233