Event Logging Configuration Parameters; Ntp Server Configuration Parameters - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

Operands
logging
Prompts you in a line-by-line fashion to change the event logging configuration parameters
described in
parameter, enter a new value or press Enter to accept the current value.
Table 56

Event logging configuration parameters

Parameter
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostAddress
Operands
ntp
Prompts you in a line-by-line fashion to change the NTP server configuration parameters
described in
parameter, enter a new value or press Enter to accept the current value.
Table 57

NTP server configuration parameters

Parameter
NTPClientEnabled
NTPServerDiscovery
NTPServerAddress
Operands
timers
Prompts you in a line-by-line fashion to change the timer configuration parameters described in
Table 58. To configure all system parameters, omit the operand. For each parameter, enter a new
value or press Enter to accept the current value.
Table 56. To configure all system parameters, omit the operand. For each
Description
Enables (True) or disables (False) the saving of log information
on the switch. The default is True.
Enables (True) or disables (False) the recording of the switch
event log on a remote host that supports the syslog protocol. The
default is False.
The IP address (version 4 or 6) or DNS host name of the host that
will receive the switch event log information if remote logging is
enabled. The default is 10.0.0.254.
Table 57. To configure all system parameters, omit the operand. For each
Description
Enables (True) or disables (False) the Network Time Protocol
(NTP) client on the switch. This client enables the switch to
synchronize its time with an NTP server. This feature supports NTP
version 4 and is compatible with version 3. An Ethernet
connection to the server is required and you must first set an initial
time and date on the switch. The synchronized time becomes
effective immediately. The default is False.
NTP boot method:
• 1—Static
• 3—DHCP (Dynamic Host Configuration Protocol)
• 3—DHCP version 6
The default is Static.
The IP address (version 4 or 6) or DNS host name of the NTP
server from which the NTP client acquires the time and date. The
default is 10.0.0.254.
8/20q Fibre Channel Switch command line interface guide 229