Table of Contents
Advertisement
•
Keep unused GBIC connectors covered with the plugs that are shipped with
them to prevent contamination from obscuring or attenuating the light sig-
nals.
Fibre Channel Cables
The fibre loop switch uses Fibre Channel cables to communicate with cascaded
and end-node devices. Loose or broken cables can cause a number of problems.
Inspect the cabling between the switch and attached Fibre Channel devices.
Check for loose, dirty, broken, or bent cabling and connectors.
1.
Inspect the switch fault LED indicators for apparent problems.
2.
Check that the GBICs are properly inserted.
3.
Check the port status LEDs.
Temperature Control
As in the case of almost all commercial electronics, the fibre loop switch is
designed to work in a normal room temperature environment, which is between
10º and 40º C. In order to maintain adequate cooling, the fibre loop switch is
equipped with fans and a filler panel.
Fans
Three fans provide forced-air cooling and operate in parallel.
Caution:
must not be blocked when installed. The operating temperature must be kept
between 10 and 40 degrees Celsius (between 50 and 104 degrees Fahrenheit).
Filler Panel
The filler panel that came with the switch must be left in the back slot in order to
direct the forced-air cooling. The GBIC slots have doors to serve the same
purpose as the filler panel and they must remain closed if a GBIC is not installed.
The air vents along the side and back panel of the fibre loop switch
Fibre Loop Switch Troubleshooting
35
Advertisement
Table of Contents
Troubleshooting
