Reconnect System To Network And Fabric - HP A7990A - StorageWorks SAN Director 4/16 Blade Switch Hardware Reference Manual

Reconnect system to network and fabric

See the cable routing information recorded in <Link>Table 19 for the following steps:
1. Connect the CP blades to the local area network:
a. Insert the appropriate Ethernet cables into each Ethernet port.
b. Connect the other ends to an Ethernet 10/100 Base-T LAN, if not already connected.
WARNING!
management tools, such as Telnet or Web Tools. Ensure that the DC Director is not modified using other
connections during the rest of this procedure.
2. Reconnect the transceivers and cables to the port blades:
NOTE: The ports and cables used in trunking groups must meet specific requirements. For a list of these
requirements, refer to the HP StorageWorks Fabric OS 6.x administrator guide.
a. Position one of the transceivers so that the key is oriented correctly to the port and insert the
transceiver into the port until it is firmly seated and the latching mechanism clicks.
b. Select the cable that corresponds to the port and position it so that the key (the ridge on one side of
the cable connector) is aligned with the slot in the transceiver; then, insert the cable into the
transceiver until the latching mechanism clicks.
c. Repeat
TIP: Do not route cables in front of the air exhaust vent (located on the upper port side of the chassis).
d. Organize the cables as required.
96 Installing Field-replaceable units (FRUs)
The DC Director can be accessed by remote connection using any of the available
step 2a and step 2c for the remaining ports.