C Regulatory Compliance And Safety Notices; Regulatory Compliance Notices; Federal Communications Commission Notice For Class A Equipment; Modifications - HP A7990A - StorageWorks SAN Director 4/16 Blade Switch Hardware Reference Manual

C Regulatory compliance and safety notices
This Appendix provides the following information:
• Regulatory compliance
• International notices and
• Environmental regulation
• Safety guidelines, page 129

Regulatory compliance notices

Federal Communications Commission notice for Class A equipment

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be required to correct the
interference at his own expense. The end user of this product should be aware that any changes or
modifications made to this equipment without the approval of Hewlett-Packard could result in the product
not meeting the Class A limits, in which case the FCC could void the user's authority to operate the
equipment.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that are not
expressly approved by Hewlett-Packard Company may void the user's authority to operate the equipment.

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods in
order to maintain compliance with FCC Rules and Regulations.

Regulatory compliance identification numbers

For the purpose of regulatory compliance certifications and identification, your product has been assigned
a unique Regulatory Model Number. The RMN can be found on the product nameplate label, along with
all required approval markings and information. When requesting compliance information for this product,
always refer to this RMN. The Regulatory Model Number should not be confused with the marketing name
or model number of the product.

Laser device

All HP systems equipped with a laser device comply with safety standards, including International
Electrotechnical Commission (IEC) 825. With specific regard to the laser, the equipment complies with
laser product performance standards set by government agencies as a Class 1 laser product. The product
does not emit hazardous light.

Laser safety warning

WARNING!
• Do not try to open the laser device enclosure. There are no user-serviceable components inside.
• Do not operate controls, make adjustments, or perform procedures to the laser device other than those
specified herein.
• Allow only HP authorized service technicians to repair the laser device.
notices, page 123
statements, page 125
compliance, page 127
To reduce the risk of exposure to hazardous radiation:
DC SAN Backbone Director hardware reference guide 123