Cable Management Comb; Removing A Cable Management Comb; Replacing A Cable Management Comb; Removing Or Replacing The Cable Management Comb - HP A7990A - StorageWorks SAN Director 4/16 Blade Switch Hardware Reference Manual

Cable management comb

The replacement procedure for the cable management comb takes less than five minutes. You will need a
#1 Phillips screwdriver.

Removing a cable management comb

CAUTION:
Wear a grounded ESD strap when handling DC Director components. The Director chassis provides a
grounding connection above the power connectors. Also,
packaging.
To remove the cable management comb:
1. Rearrange the cables around the cable management comb.
2. Unscrew and save the four screws holding the comb to the chassis (see
prevent it from falling
3. Remove the cable management comb

Replacing a cable management comb

To replace a cable management comb (see
1. Position and tighten the four screws to secure the cable management comb to the chassis.
2. Arrange the cables along the cable management comb.
Figure 27

Removing or replacing the cable management comb

store ESD-sensitive components in antistatic
Figure 27):
DC SAN Backbone Director hardware reference guide
Figure 27). Support the comb to
26384a
65