Upgrading Or Restoring The Switch Firmware; Downloading Firmware From The Hp Website - HP AA-RSB6B-TE Installation Manual

Saving Configuration Settings and Upgrading Firmware

Upgrading or Restoring the Switch Firmware

The SAN Switch 2/8 ships with preloaded firmware. In most cases there is no
need to update the firmware on the new switch. The firmware version can be
determined by using:
Use these steps to upgrade or restore the switch firmware.
1. Verify that the RSHD service or the FTP service is running on the host
2. Login to the switch as the admin user.
3. At the command line, type:
Note:
4. Reboot the switch by entering the following command:

Downloading Firmware from the HP Website

To download the firmware from the HP website, go to
http://www.hp.com/support. The website contains the required loaders and
instructions for downloading the firmware to a switch.
76
The version Telnet command
The Switch Management Application page in Web Management Tools
workstation.
firmwareDownload hostIPaddr, user, path_filename, password
For example, where hostIPaddr is the IP address of the host computer,
user is the User ID used to log into this computer, path_filename is the
path location and filename of the new firmware file, and password is the
password for the user ID specified.
The password operand is only required if you are using FTP.
fastBoot
hp StorageWorks SAN Switch 2/8 Installation Guide