Prerequisites For Upgrading Or Restoring Firmware - HP StorageWorks 2/32 - SAN Switch Release Note

Note:
Version 4.0.2b firmware and future upgrades are available on the HP website at:
http://h18006.www1.hp.com/products/storageworks/fcsanswitch232/index.html

Prerequisites for Upgrading or Restoring Firmware

Read this section before upgrading/restoring switch firmware.
Verify that a Windows NT or 2000 FTP Server is Installed
An FTP server must be installed and running when performing the telnet
command configUpload on a Windows NT or 2000 system. If you do not
have a Microsoft Windows NT or 2000 FTP service previously installed on your
system, you need to install it.
Use the following steps to install and configure a Windows NT or 2000 FTP
server.
1. Create a folder for the switch firmware and configuration files.
2. Install the Windows NT or 2000 FTP server on your system from your
Note:
specify the folder created in step 1 as the FTP Publish Directory.
3. Open the Internet Service Manager Tool.
4. Issue the configUpload command. Save the configuration.
SAN switch 2/32 Version 4.0.2b Release Notes
SAN Switch 2/32 products require firmware Version 4.0.2b or higher.
Windows installation CD.
If you only use the FTP server for the firmware and configuration loads, you can
Prerequisites for Upgrading or Restoring Firmware
11