Configuring Igmp Filtering (Cli Example); Configuring A Static Mrouter (Cli Example) - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Application Manual

Configuring IGMP Filtering (CLI example)

1.
Enable IGMP Filtering on the switch.
>> /cfg/l3/igmp/igmpflt
>> IGMP Filter# ena
Current status: disabled
New status: enabled
2.
Define an IGMP Filter.
>> //cfg/l3/igmp/igmpflt
>>IGMP Filter# filter 1
>>IGMP Filter 1 Definition# range 224.0.1.0
Current multicast address2:
Enter new multicast address2: 226.0.0.0
Current multicast address1:
New pending multicast address1: 224.0.1.0
Current multicast address2:
New pending multicast address2: 226.0.0.0
>>IGMP Filter 1 Definition# action deny
>>IGMP Filter 1 Definition# ena
3. Assign the IGMP Filter to a port.
>> //cfg/l3/igmp/igmpflt
>>IGMP Filter# port 24
>>IGMP Port 24# filt ena
Current port 24 filtering: disabled
New port 24 filtering: enabled
>>IGMP Port 24# add 1
>>IGMP Port 24# apply

Configuring a Static Mrouter (CLI example)

1.
Configure a port to which the static Mrouter is connected, and enter the appropriate VLAN.
>> /cfg/l3/igmp/mrouter
>> Static Multicast Router# add 20
Enter VLAN number: (1-4094) 1
Enter the version number of mrouter [1|2|3]: 2 (Enter the IGMP
2.
Apply, verify, and save the configuration.
>> Static Multicast Router# apply
>> Static Multicast Router# cur
>> Static Multicast Router# save
(Select IGMP Filtering menu)
(Enable IGMP Filtering)
(Select IGMP Filtering menu)
(Select Filter 1 Definition menu)
(Enter first IP
address of the range)
(Enter second IP
address of the range)
(Deny multicast traffic)
(Enable the filter)
(Select IGMP Filtering menu)
(Select port 24)
(Enable IGMP Filtering on the port)
(Add IGMP Filter 1 to the port)
(Make your changes active
(Select IGMP Mrouter menu)
(Add port 20 as Static
Mrouter port)
(Enter the VLAN number)
version number)
(Apply the configuration)
(View the configuration)
(Save the configuration)
IGMP Snooping
120