Cli: Configuring And Displaying Igmp - HP ProCurve 2910al Switch Manual

CLI: Configuring and Displaying IGMP

IGMP Commands Used in This Section
show ip igmp configuration
ip igmp
high-priority-forward
auto <[ethernet] <port-list>
blocked <[ethernet] <port-list>
forward <[ethernet] <port-list>
querier
show ip igmp
Viewing the Current IGMP Configuration. This command lists the IGMP
configuration for all VLANs configured on the switch or for a specific VLAN.
Syntax: show ip igmp config
Displays IGMP configuration for all VLANs on the switch.
show ip igmp vlan < vid > config
Displays IGMP configuration for a specific VLAN on the
switch, including per-port data.
(For IGMP operating status, refer to the section titled "Internet Group Man­
agement Protocol (IGMP) Status" in appendix B, "Monitoring and Analyzing
Switch Operation" of the Management and Configuration Guide for you
switch.)
Multimedia Traffic Control with IP Multicast (IGMP)

CLI: Configuring and Displaying IGMP

page 2-7
page 2-9
page 2-11
page 2-10
page 2-10
page 2-10
page 2-11
Refer to the section titled "Internet Group
Management Protocol (IGMP) Status" in appendix B
of the Management and Configuration Guide for your
switch.
2-7