Configuration guidelines
This section provides important information about configuring UFD:
UFD is required only when uplink-path redundancy is not available on the blade switches.
Only one Failure Detection pair (one group of Links to Monitor and one group of Links to Disable) is
supported on each switch (all VLANs and Spanning Tree Groups).
An LtM can be either one uplink port or one Multi-Link trunk group of uplink ports.
Ports that are already members of a trunk group are not allowed to be assigned to an LtM.
A trunk group configured as an LtM can contain multiple uplink ports (19-25), but no downlink
ports (1-16) or interconnect ports (17).
An uplink port cannot be added to a trunk group if it already belongs to an LtM.
An LtD can contain one or more ports, and/or one or more trunks
A trunk group configured as an LtD can contain multiple downlink ports (1-16), but no uplink
ports (19-25) or interconnect ports (17).
Monitoring Uplink Failure Detection
The UFD information menu displays the current status of the LtM and LtD, and their member ports or
trunks. For example:
>> Information# ufd
Uplink Failure Detection: Enabled
LtM status: Down
Member
---------
port 24
* = STP turned off for this port.
LtD status: Auto Disabled
Member
---------
port
port
port
port
Use the /stats/ufd command to find out how many times link failure was detected on the LtM, how
many times Spanning Tree blocking state was detected on the LtM, and how many times UFD disabled
ports in the LtD.
Configuring Uplink Failure Detection
The preceding figure shows a basic UFD configuration. Assume that port 21 on Blade Switch 1 is
connected to a Layer 2/3 routing switch outside of the chassis. Port 22 and port 23 on Blade Switch 2
form a trunk that is connected to a different Layer 2/3 routing switch. The interconnect ports (17) are
disabled.
STG
STG State
---
------------
1
DISABLED
10
DISABLED *
15
DISABLED *
Link Status
-----------
1
disabled
2
disabled
3
disabled
4
disabled
Link Status
-----------
down
High availability
166