Starting The Management And Configuration Program In The Management Module; Connecting To The Management Module Through A Directly Connected Computer - IBM JS20 - BladeCenter - 8842 Installation And User Manual

v Before you can run programs on the blade server, you must install an operating
v Throughout this document, the management-module Web-based user interface is
v Throughout this document, the user name is also known as the user identifier or
Starting the management and configuration program in the
management module
Use the management-module Web-based management and configuration program
for:
v Configuring the BladeCenter unit to operate using SOL
v Updating and configuring BladeCenter components for SOL operation
Complete the following steps to start the Web-based management and
configuration program. (For additional information, see the BladeCenter unit
Installation and User's Guide.)
1. Open a Web browser. In the address or URL field, type the Internet protocol (IP)
2. Type your user name and password. Before you log onto the management
3. Follow the instructions that appear on the screen. Be sure to set the timeout
The BladeCenter management and configuration window opens.
Connecting to the management module through a directly connected
computer
The computer that you are connecting to the management module must be
configured to operate on the same subnet as the BladeCenter management
module. If the IP address of the management module is outside of your local
domain, you must change the Internet protocol properties on the computer that you
are connecting.
To access the management model through a direct-attached computer after initial
BladeCenter installation and configuration, complete the following steps:
system on the blade server. For information about installing the operating system,
see Chapter 6, "Installing the operating system," on page 45.
also known as the BladeCenter management-module Web interface.
user ID for logging onto the management module.
address or host name that is assigned for the management-module remote
connection. The default IP address is:
192.168.70.125
The Enter Network Password window opens.
module for the first time, contact your system administrator regarding whether
your organization has assigned a user name and password to you. Use the
initial (default) user name and password the first time that you log onto the
management module. If you have an assigned user name and password, use
them for all subsequent logins. All login attempts are documented in the event
log.
The initial user ID and password for the management module are:
v User ID: USERID (all capital letters)
v Password: PASSW0RD (note the number zero, not the letter O, in
PASSW0RD)
value that you want for your Web session.
Chapter 5. Configuration requirements for the blade server
37