IBM JS20 - BladeCenter - 8842 Installation And User Manual page 78

Table 1. Abbreviated list of firmware error codes (continued)
Error code Failing device or problem found
20A80005 The trivial file transfer protocol
(TFTP) failed.
20A80006 The startup image is too large.
20A80100 A SAN device was found in the boot
list; however, the ibm,fw-fcpdisk
alias name has not been defined in
the /alias node.
20A80102 The ibm,fw-fcpdisk alias is not a
SAN device.
20A80104 The disk2 alias was found and
copied to the ibm,fw-fcpdisk alias.
20A80110 The ibm,fw-fcpdisk alias was
modified.
20D0000F The device failed the self-test; error
or location code information might not
be available.
20D00010 The device failed the self-test; cannot
locate package.
20D00011 The run-time extraction services
(RTAS) program attempt to allocate
memory failed.
66
BladeCenter JS20 Type 8842: Installation and User's Guide
Suggested action
1. Make sure that the BOOTP server is correctly
configured for this client.
2. Check the network connection. If the network
connection is good, retry the operation. If there is no
network connection, contact your network
administrator.
3. If there are no problems with the BOOTP server or the
network connection, replace the system-board
assembly. Contact a service support representative for
more information.
1. Make sure that the BOOTP server is correctly
configured for this client.
2. Check the network connection. If the network
connection is good, retry the operation. If there is no
network connection, contact your network
administrator.
3. If there are no problems with the BOOTP server or the
network connection, replace the system-board
assembly. Contact a service support representative for
more information.
Type the setup-fc-disk command at the open firmware
prompt and press Enter; then, restart the blade server.
Run the setup-fc-disk utility.
This is an informational message. No action is required.
This is an informational message. No action is required.
v If a location code is specified, replace the device at that
location.
v Perform the system checkout procedure. See "System
checkout" on page 48.
1. If a location code is reported with the error, replace
the device at that location code.
2. Replace the system-board assembly. Contact a
service support representative for more information.
Perform the system checkout procedure. See "System
checkout" on page 48.