Related Documentation - IBM JS20 - BladeCenter - 8842 Installation And User Manual

The machine type, model number, and serial number are on the identification label
that is behind the control-panel door on the front of the blade server, and on a label
on the side of the blade server that is visible when the blade server is not in the
BladeCenter unit. You will need these numbers when you register the blade server
with IBM.
Identification
label
Control-panel
door
Release
levers
Note: Make sure that you review and understand the design of the BladeCenter
A set of blank labels comes with the blade server. When you install the blade server
in the BladeCenter unit, write identifying information on a label and place the label
on the BladeCenter unit bezel. See the documentation for your BladeCenter unit for
recommended label placement.
Important: Do not place the label on the blade server or in any way block the

Related documentation

In addition to this Installation and User's Guide, the following related documentation
is available in PDF on the World Wide Web or on the IBM BladeCenter JS20
Documentation CD that comes with the IBM BladeCenter JS20 Type 8842:
v Safety Information: This document contains translated caution and danger
2
BladeCenter JS20 Type 8842: Installation and User's Guide
unit. Use this information to help you determine your system configuration
requirements and the bays and connectors where you will install or remove
components. For additional information, see the BladeCenter unit Installation
and User's Guide on the Documentation CD for your BladeCenter unit, or go
to http://www.ibm.com/support/ on the World Wide Web.
ventilation holes on the blade server.
statements. Each caution and danger statement that appears in the
documentation has a number that you can use to locate the corresponding
statement in your language in the Safety Information document.