Starting The Management And Configuration Program In The Management Module; Global Sol Settings And Status - IBM eServer BladeCenter JS20 Installation And User Manual

Starting the management and configuration program in the
management module
Complete the following steps to start the Web-based management and configuration
program:
1. Access and log onto the BladeCenter management-module Web interface as
2. Open a Web browser. In the address or URL field, type the Internet protocol (IP)
3. Type your user name and password. Before you log onto the management
4. Follow the instructions that appear on the screen. Be sure to set the timeout
The BladeCenter management and configuration window opens.

Global SOL settings and status

Use the Serial Over LAN choice under Blade Tasks to view and change the global
SOL settings that are used by all blade servers installed in the BladeCenter unit.
You can also use this choice to enable or disable SOL for each blade server.
44
BladeCenter JS20 Type 8842: Installation and User's Guide
described in the IBM Eserver BladeCenter Type 8677 Installation and User's
Guide on the IBM BladeCenter Documentation CD.
address or host name that is assigned for the management-module remote
connection.
The Enter Network Password window opens.
module for the first time, contact your system administrator regarding whether
your organization has assigned a user name and password to you. Use the
initial (default) user name and password the first time that you log onto the
management module. If you have an assigned user name and password, use
them for all subsequent logins. All login attempts are documented in the event
log.
Note: The initial user ID and password for the management module are:
v User ID: USERID (all capital letters)
v Password: PASSW0RD (note the number zero, not the letter O, in
PASSW0RD)
value that you want for your Web session.