IBM JS20 - BladeCenter - 8842 Installation And User Manual page 71

Checkpoint code Description
E1FB Reserved
E1FC Build the boot list for serial storage
architecture (SSA) adapters. The
location code of the SSA adapter
being scanned is also displayed.
E1FD E1FD and another progress code
(Exxx) will alternate in the operator
panel. The other code indicates
where the error occurred.
E1FE Build the boot list for Fibre Channel
adapters. The world-wide port
number (WWPN) of the SAN adapter
being scanned is also displayed.
E1FF Building the boot list for Fibre
Channel adapters. The WWPN of the
SAN adapter being scanned is also
displayed.
E199 Restarting (rebooting) the partition to
activate the changes that are
specified in the boot-image's
executable and linkable format (ELF)
header.
2
E200 I C bus controller initialization.
E201 The flash random-access memory
(RAM) cyclic redundancy check
(CRC) checksum is valid.
E202 Programmable interrupt controller
(MPIC) initialization.
Suggested action
Have the blade server serviced.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Check the http://www.ibm.com/support Web site for
a later firmware version that might address the
problem. For additional information, see "Updating
the firmware code for the blade server and the
service processor" on page 40.
2. If a later firmware version is not available, or if the
problem remains after you update the firmware
code, go to the "Boot problem resolution" section in
the BladeCenter JS20 Type 8842 Hardware
Maintenance Manual and Troubleshooting Guide.
Follow the instructions in that section.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. If the problem remains, force the system to start
from the PERM flash image to reflash the TEMP
image for recovery. See "Recovering the system
firmware code" on page 84.
3. If the problem remains, replace the blade server.
Contact a service support representative for
assistance.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
1. Perform the system checkout procedure. See
"System checkout" on page 48.
2. This error indicates that you might have a problem
with the system board. Contact a service support
representative for more information.
Chapter 7. Solving problems
59