Table of Contents
Advertisement
Errata
Errata
BG1.
The Processor May Report a #TS Instead of a #GP Fault
Problem:
A jump to a busy TSS (Task-State Segment) may cause a #TS (invalid TSS exception)
instead of a #GP fault (general protection exception).
Implication: Operation systems that access a busy TSS may get invalid TSS fault instead of a #GP
fault. Intel has not observed this erratum with any commercially-available software.
Workaround:None identified.
Status:
For the steppings affected, see the Summary Tables of Changes.
BG2.
REP MOVS/STOS Executing with Fast Strings Enabled and Crossing Page
Boundaries with Inconsistent Memory Types May Use an Incorrect Data Size
or Lead to Memory-Ordering Violations
Problem:
Under certain conditions as described in the Software Developers Manual section "Out-
of-Order Stores For String Operations in Pentium® 4, Intel Xeon, and P6 Family
Processors" the processor performs REP MOVS or REP STOS as fast strings. Due to this
erratum fast string REP MOVS/REP STOS instructions that cross page boundaries from
WB/WC memory types to UC/WP/WT memory types, may start using an incorrect data
size or may observe memory ordering violations.
Implication: Upon crossing the page boundary the following may occur, dependent on the new page
memory type:
•
UC the data size of each write will now always be 8 bytes, as opposed to the
original data size.
•
WP the data size of each write will now always be 8 bytes, as opposed to the
original data size and there may be a memory ordering violation.
•
WT there may be a memory ordering violation.
Workaround:Software should avoid crossing page boundaries from WB or WC memory type to UC,
WP or WT memory type within a single REP MOVS or REP STOS instruction that will
execute with fast strings enabled.
Status:
For the steppings affected, see the Summary Tables of Changes.
Specification Update
17
Advertisement
Table of Contents
