The DNS Server fields appear only if LDAP Authentication is licensed on the console switch.
To change network parameters:
Select Network.
1.
Select Enabled if a BOOTP server is to be used to obtain the network configuration. The remaining
2.
fields on this panel are disabled.
-or-
Select Disabled if a static network configuration is used to obtain the network configuration.
In the IP Address field, enter the address in IP dot notation of the console switch. The value
a.
cannot be a loopback address or all zeros.
In the Subnet Mask field, enter the subnet mask in IP address dot notation of the console switch.
b.
The value cannot be a loopback address or all zeros.
In the Gateway field, enter the gateway address in IP address dot notation of the console switch.
c.
The value cannot be a loopback address. If there is no gateway address, enter 0.0.0.0.
In the DNS Servers fields, enter the address in IP dot notation of up to three DNS servers.
d.
Click Apply to save any changes without exiting.
3.
-or-
Managing KVM console switches 39