HP 262586-B21 - IP Console Switch 3x1x16 KVM User Manual page 101

The DNS Servers field appears only if LDAP Authentication is licensed on the serial console switch.
To change network parameters:
Select Network.
1.
Select Enabled if a BOOTP server is to be used to obtain the network configuration. The remaining
2.
fields on this panel are disabled.
-or-
Select Disabled if a static network configuration is to used to obtain the network configuration.
In the IP Address field, enter the address of the serial console switch in IP dot notation. The value
a.
cannot be a loopback address or all zeros.
In the Subnet Mask field, enter the subnet mask of the serial console switch in IP address dot
b.
notation. The value cannot be a loopback address or all zeros.
In the Gateway field, enter the gateway address of the serial console switch in IP address dot
c.
notation. The value cannot be a loopback address. If there is no gateway address, enter
0.0.0.0.
In the DNS Servers fields, enter the address in IP dot notation of up to three DNS server.
d.
Managing serial console switches 101