When the NFS feature is enabled, the port history data is written to a file on an NFS server, in addition to
the local history buffer on the serial console switch. Each port has its own files on the NFS server where
data is written.
When the NFS feature is not enabled, all of the parameters in the NFS subcategory are disabled.
To configure NFS parameters:
Select NFS.
1.
Select the Enable NFS checkbox.
2.
Select TCP or UDP for a network protocol that is used for communications between the serial console
3.
switch and the NFS server.
Enter an NFS server IP address.
4.
Enter a mount point on the NFS server.
5.
Select Linear to have a new file. A file is opened for writing at the end (appended).
6.
-or-
Select Daily to have a new file. A new file is created every midnight.
Managing serial console switches 112