Figure 108. Removing Memory Riser Cage - Intel SC5400RA - Server System - 0 MB RAM User Manual

8. Reach in through the memory riser cage to disconnect the two power cables from
the server board. If necessary, clip the wire tie that holds the two cables together.
Use caution so you do not cut any of the cables.
9. Remove the two screws that secure the memory riser cage to the server system. See
letter "A" in the figure below.
10. Lift the memory riser cage from the server system. See letter "B" in the figure
below.
11. Remove both processor heatsinks. For instructions, see
page
12. Remove each processor. For instructions, see
13. Remove each PCI add-in card.
14. Remove the Intel
are installed. For instructions, see
RMM NIC" on page
15. Disconnect all remaining power and data cables from the server board.
16. Remove the eight screws that secure the server board to the chassis.
17. Lift the server board from the chassis.
Intel® Server System SC5400RA User's Guide

Figure 108. Removing Memory Riser Cage

77.
®
Remote Management Module and the Intel
81.
A
B
"Removing a Processor" on page
"Removing the Intel
AF001409
"Removing a Heatsink" on
®
RMM NIC if they
® ®
RMM and the Intel
74.
101