Installing And Removing Hot-Swap Drive(S); Installing Hot-Swap Drive(S); Figure 33. Removing Drive Carrier From Hot-Swap Cage; Figure 34. Removing Plastic Air Baffle - Intel SC5400RA - Server System - 0 MB RAM User Manual

Installing and Removing Hot-swap Drive(s)

Your server system will have either hot-swap or fixed drives. If your server system has
fixed drives, see
installation and removal steps.

Installing Hot-swap Drive(s)

1. Press in on the green latch at the end of the drive carrier to disengage it from the hot
swap drive cage. See letter "A" in the following figure.
2. Pull out on the black lever to fully open the drive carrier. See letter "B" in the
figure.
3. When the lever reaches a fully opened position, it will push the drive carrier out
from the hot swap drive cage. Slide the drive carrier out of the drive cage. See letter
"C"..
4. Remove the four screws that secure the plastic air baffle to the drive carrier.
Remove the plastic air baffle.
38
"Installing and Removing Fixed Hard Drive(s)" on page 28

Figure 33. Removing Drive Carrier from Hot-swap Cage

Figure 34. Removing Plastic Air Baffle

A
B
C
AF000589
AF000590
Intel® Server System SC5400RA User's Guide
for drive