Solving Problems; Resetting The System; Initial System Startup; Checklist - Intel SC450NX - Server Platform - 0 MB RAM Product Manual

Server system
Table of Contents

Advertisement

7 Solving Problems

This chapter helps you identify and solve problems that might occur while you are using the
system.

Resetting the System

To do this:
Soft boot reset, which clears system memory and reloads the operating system.
Clear system memory, restart POST, and reload the operating system.
Cold boot reset, which clears system memory, restarts POST, reloads the
operating system, and halts power to all peripherals.

Initial System Startup

Problems that occur at initial system startup are usually caused by incorrect installation or
configuration. Hardware failure is a less frequent cause.

Checklist

Y
Are all cables correctly connected and secured?
Y
Are the processors fully seated in their slots on the baseboard?
Y
Are all add-in ISA and PCI boards fully seated in their slots on the baseboard?
Y
Are all switch and jumper settings on the baseboard correct?
Y
Are all jumper and switch settings on add-in boards and peripheral devices correct? To check
these settings, refer to the manufacturer's documentation that comes with them. If applicable,
ensure that there are no conflicts—for example, two add-in boards sharing the same interrupt.
Y
Are all DIMMs installed correctly?
Y
Are all peripheral devices installed correctly?
Y
If the system has a hard disk drive, is it properly formatted or configured?
Y
Are all device drivers properly installed?
Y
Are the configuration settings made with the SSU correct?
Y
Is the operating system properly loaded? Refer to the operating system documentation.
Y
Did you press the system power on/off switch on the front panel to turn the server on
(power-on light should be lit)?
Y
Are the system power cords properly connected to the system and plugged into a
NEMA 5-15R outlet for 100-120 V or a NEMA 6-15R outlet for 200-240 V ?
Y
Y
Is AC power available at the wall outlet?
If these items are correct but the problem recurs, see "More Problem-solving Procedures" on
page 125.
Press:
<Ctrl+Alt+Del>
Reset button
Power off/on
123

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc450nx mp

Table of Contents