Table of Contents
Advertisement
8. Position the drive so the plastic slide rails engage in the bay guide rails. Push the drive into the
bay until the slide rails lock in place.
9. Connect a power cable to the drive. The connectors are keyed and can be inserted in only one
way.
10. Connect a signal cable to the drive. The connectors are keyed and can be inserted in only one
way.
SCSI drive: Attach connectors on the cable to the SCSI device or devices you are
installing.
IDE drive: The baseboard has one IDE connector. It can support an IDE signal cable up
to 18 inches long. See Figure 29 on page 97 for the cable dimensions.
11. Close the front bezel.
100
C
Figure 31. Snap-in Plastic Slide Rails
A.
Tape drive or other removable media device
B.
Tab on slide rail
C. Screws (4)
D. Slide rails (2)
D
A
OM08013
B
Advertisement
Table of Contents
