Disaster Recovery For Newer Windows - HP BB118BV - StorageWorks Data Protector Express Package User's Manual & Technical Reference

6.
Create a restore job.
7.
Select Windows Active Directory for the restore job from the Selection page.
8.
Run the restore job.
9.
Exit Data Protector Express.
10.
Restart the computer, letting Windows load normally.
1 1.
Verify that Windows active directory is running properly.

Disaster recovery for newer Windows

This section is applicable to ...
• Windows Vista and
• Windows Server 2008.
To perform Disaster Recovery for one of the operating system listed above, do the following:
1. Insert the first bootable media into a drive or, if using a library, into any slot that can be booted from.
2. Perform any special steps for booting your computer from the bootable device. (Refer to your device
and system documentation.) Most bootable drives use a combination of power cycling and pressing
the Eject button on the front panel. Many also require that you update the computer BIOS.
NOTE:
For disaster recovery, use only full backup media that were created with the Overwrite all media
option. After disaster recovery is complete and your system has restarted, use the standard Data
Protector Express options to restore any incremental or differential media to your system. The
standard Data Protector Express restore procedure optimizes restoration and restores incremental
and differential media faster than the disaster recovery process.
NOTE:
One-Button Disaster Recovery (OBDR) may take several minutes to boot to a screen which
indicates progress. During this time, the screen will appear blank.
3. When the computer boots from the recovery media, the Disaster Recovery Wizard welcome screen
appears. Click the Continue button.
User's Guide and Technical Reference
229