Removing the cover
The following information describes how to remove the cover.
Complete the following steps to remove the cover from the server/workstation:
1. Review the information in "Before you begin" on page 45.
2. Turn off the server/workstation and all attached devices and disconnect all
3. Remove the server/workstation from the rack (see "Rack installation" on
4. Remove the two screws from the rear of the server/workstation.
5. Pull out on the cover release lever at the back of the server/workstation, to
6. Slide the cover back, then up and off the server/workstation.
7. Remove the clear shield that covers the inside of the server/workstation.
48
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674
Cover release
lever
external cables and power cords.
page 46).
release the cover.
Attention:
For proper cooling and airflow, replace the cover before turning
on the server/workstation. Operating the server/workstation for extended
periods of time (over 30 minutes) with the cover removed might damage
server/workstation components.
Note: It is not necessary to remove the shield when you are installing memory
modules or installing an adapter in the PCI slots.
Screws