Power Checkout - IBM 867413x - Eserver xSeries 330 8674 Hardware Maintenance Manual

Table 6. NDIS (Windows NT or Windows 2000) driver teaming messages for the Ethernet controller (continued)
Event ID Type
04 Error
05 Error
06 Informational
07 Informational
08 Informational
09 Informational
10 Warning
11 Informational
12 Warning
13 Informational
14 Informational
15 Error
16 Informational
17 Informational
18 Informational
19 Informational
20 Informational
21 Warning

Power checkout

Power problems can be difficult to troubleshoot. For instance, a short circuit can
exist anywhere on any of the power distribution busses. Usually a short circuit will
cause the power subsystem to shut down because of an overcurrent condition.
A general procedure for troubleshooting power problems is as follows:
1. Power off the system and disconnect the AC cord(s). Disconnect all external
22
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674
Description
Explanation: Unable to bind to physical adapter. Action: Reconfigure the
adapter team by double-clicking the PROSet icon in the control panel.
Explanation: Unable to initialize an adapter team. Action: Reconfigure
the adapter team by double-clicking the PROSet icon in the control panel.
Explanation: Team nn. Primary adapter is initialized. Action: None.
Explanation: Team nn. Secondary adapter is initialized. Action: None.
Explanation: Team nn. Virtual adapter or Team is initialized. Action:
None.
Explanation: Team nn. Primary adapter is switching over. Action: None.
Explanation: Team nn. Adapter link down. Action: Make sure the
adapter is functioning properly.
Explanation: Team nn. Secondary adapter took over. Action: None.
Explanation: Team nn. Secondary adapter is deactivated from the Team.
Action: Make sure the secondary adapter is functioning properly and
that the adapter cable is securely connected to the LAN.
Explanation: Team nn. Secondary adapter has rejoined the Team. Action:
None.
Explanation: Team nn. Secondary adapter link is up. Action: None.
Explanation: Team nn. The last adapter has lost its link. Network
connection has been lost. Action: Shut down the server/workstation and
replace the adapters; then, restart the server/workstation to reestablish
the connection.
Explanation: Team nn. An adapter has re-established the link. Network
connection has been restored. Action: None.
Explanation: Team nn. Preferred primary adapter has been detected.
Action: None.
Explanation: Team nn. Preferred secondary adapter has been detected.
Action: None.
Explanation: Team nn. Preferred primary adapter took over. Action:
None.
Explanation: Team nn. Preferred secondary adapter took over. Action:
None.
Explanation: Team nn. Primary adapter does not sense any Probes.
Possible reason: partitioned Team. Action: Make sure the cables of the
adapter team are connected to the same LAN segment. Reconfigure the
team if necessary.
cables and remove server/workstation from the rack.