Table of Contents
Advertisement
Memory Settings from the Advanced Setup menu, use the arrow keys to
highlight the bank that you want to enable; then, use the arrow keys to select
Enable.
v Error Logs
Select this choice to view or clear error logs.
– Select POST Error Log to view the three most recent error codes and
messages that the system generated during POST.
Select Clear error logs from the POST Error Log menu to clear the error log.
– Select System Event/Error Log to view the system event/error log. The
system event/error log contains all the system error and warning messages
that the system has generated. You can use the arrow keys to move between
pages in the system event/error log.
Select Clear error logs from the System Event/Error Log menu to clear the
error or event log.
v Save Settings
Select this choice to save your customized settings.
v Restore Settings
Select this choice to delete your changes and restore the previous settings.
v Load Default Settings
Select this choice to cancel your changes and restore the factory settings.
v Exit Setup
If you have made any changes, the program will prompt you to save the
changes or exit without saving the changes.
Using passwords
The System Security choice appears only on the full Configuration/Setup Utility
menu. After you select this choice, you can implement two levels of password
protection: power-on password and administrator password.
Power-on password
After you set a power-on password, you can enable the unattended-start mode.
This locks the keyboard and mouse, but allows the system to start the operating
system. The keyboard and mouse remain locked until you enter the correct
password.
You can use any combination of up to seven characters (A–Z, a–z, 0–9 and blanks)
for your power-on password. Keep a record of your password in a secure place. If
you forget the power-on password, you can regain access to the
server/workstation through one of the following methods:
v If an administrator password is set, enter the administrator password at the
power-on prompt. Start the Configuration/Setup Utility program and change the
power-on password.
v Change the position of the password override jumper as described in "Setting
the password override switch".
v Remove the battery and then install the battery.
Setting the password override switch: The following illustration shows the
location of the password override switch, switch 4 of switch block 1, on the system
board.
31
Configuration
Advertisement
Table of Contents
