Post; Post Error Messages; Event/Error Logs; Small Computer System Interface Messages - IBM 867413x - Eserver xSeries 330 8674 Hardware Maintenance Manual

POST

When you turn on the server/workstation, it performs a series of tests to check the
operation of server/workstation components and some of the options installed in
the server/workstation. This series of tests is called the power-on self-test or POST.
If POST finishes without detecting any problems, a single beep sounds and the
first screen of your operating system or application program appears.
If POST detects a problem, more than one beep sounds and an error message
appears on your screen. See "POST error messages" for more information.
Notes
1. If you have a power-on password set, you must type the password and press
2. A single problem might cause several error messages. When this occurs, work

POST error messages

The table "POST error codes" on page 127 provides information about the POST
error messages that can appear during startup.

Event/error logs

The POST error log contains the three most recent error codes and messages that
the system generated during POST. The System Event/Error log contains all
messages issued during POST and all system status messages from the Advanced
System Management Processor.
To view the contents of this error log, start the Configuration/Setup Utility
program; then, select Event/Error Logs from the main menu.

Small computer system interface messages

The following table lists actions to take if you receive a SCSI error message.
Note: If the server/workstation does not have a hard disk drive, ignore any
You will get these messages only when running the SCSISelect Utility. See "SCSI
error codes" on page 131.
12
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674
™
:
Enter, when prompted, before POST will continue.
to correct the cause of the first error message. After you correct the cause of the
first error message, the other error messages usually will not occur the next
time you run the test.
message that indicates that the drive is not installed.