Turning On The Server - IBM 867413x - Eserver xSeries 330 8674 Hardware Maintenance Manual

USB 1: Universal Serial Bus 1
System-error light: This amber LED lights when a system error occurs. An LED on
the Light Path Diagnostic panel on the system board may also be on to further
isolate the error. This light duplicates the system error light on the front of the
server.
Power-on light: This green LED lights and stays on when you turn on your server
and will blink when the server is in standby mode. This light duplicates the power
on light on the front of the server.
Ethernet 2 link indicator: This green LED lights when there is an active link
connection on the 10BASE-T or 100BASE-TX interface for Ethernet port 2.
Ethernet 2 speed indicator: This green LED lights when the speed of the Ethernet
LAN connected to Ethernet port 2 is 100 Mbps.

Turning on the server

Turning on the server refers to the act of plugging the power cord of your server
into the power source and starting the operating system.
Complete the following steps to turn on the server:
1. Plug the power cord of your server into the power source.
2. Wait 30 seconds then press the power control button on the front of the server.
v You can press the Power control button on the front of the server to start the
v If the server is turned on and a power failure occurs, the server will start
v The Advanced System Management Processor can also turn on the server.
CAUTION:
The power control button on the device and the power switch on the power supply (if
there is one) do not turn off the electrical current supplied to the device. The device also
might have more than one power cord. To remove all electrical current from the device,
ensure that all power cords are disconnected from the power source.
8
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674
Note: Plugging the power cord into a power source may cause the server to
start automatically. This is an acceptable action.
server.
Note: After you plug the power cord of your server into an electrical outlet,
wait approximately 30 seconds before pressing the Power control button.
During this time, the system-management processor is initializing and the
Power control button does not respond.
automatically when power is restored.